Unscrew the shower head by turning it counterclockwise. If it is difficult to remove the
shower head by hand, try using a wrench or pliers. To avoid scratching the finish, wrap acloth around the jaws of the pliers

Clean the threads. Make sure there is a rubber washer is inside the valve before
installing. Turn the valve clockwise till it is hand tight and position the hose outlet down.
To avoid scratching the finish, wrap a cloth around the jaws of the pliers if needed to
tighten the valve.

Make sure there is a rubber washer is inside the shower head before installing. Turn the
shower head clockwise till it is hand tight. To avoid scratching the finish, wrap a cloth
around the jaws of the pliers if needed to tighten the shower head.

On the shower hose outlet, turn the shower hose clockwise till it is hand tight and let the hose hang down. To avoid scratching the finish, wrap a cloth around the jaws of the pliers.

Pick a spot on a smooth, flat, non porous surface where you would like to mount the
nozzle. Clean that spot to where it is squeaky clean about 5 inches around. Get the
Suction Cup Nozzle Holder wet on the suction cup, firmly press the suction cup against
the cleaned surface and flip the handle to draw in the suction cup

Final step. Take the Frumunda Nozzle and screw it into the unattached end of the
shower hose hand tight. Slide the attached Frumunda Nozzle into the nozzle holder and that’s it… All done. Now it is time to enjoy your new ability to clean every nook and
cranny.